The FLANGE HOG 110 is rugged, compact and ideal for quickly reconditioning rusty, scarred or worn flange gasket seats to like-new condition in minutes.
This easy to operate flange facing tool is perfect for re-facing raised-face and flat-faced flanges on site or in a fabrication/repair shop.
The ESCO proprietary clamping system is simple to configure and designed for fast set-up with accurate alignment.
The FLANGE HOG 110 has a clamping range from 0.9″ / 22.9mm to 10.3″ / 261.6mm and can machine flanges with a reach up to 14″ / 355.6mm O.D. The ESCO proprietary clamping system is simple to configure and designed for fast set up with accurate alignment.
Cutting bits are double sided, long-lasting, and specially formed to cut through a wide variety of material including carbon steel, stainless steel, alloyed steel, aluminum and cast iron.
Each tool kit comes ready to use in a sturdy carrying case that keeps everything conveniently organized and readily accessible.
FLANGE HOG 110 COMPLETE KIT #: FL-110
(1) Housing, gear drive, feed assy (stock finish)
(1) Small wedge with Draw Rod and Actuator
(1) Large wedge with Draw Rod and Actuator
(1) Insert Holder, straight
(1) Insert Holder, double pocket
(10) Insert, 1/4″
(4) Insert screw
(6) Spring, 12″ long
(3) Clamp rib sets G-04 – G-06
(8) Clamp Rib sets H-01 – H-08
(1) Tool Post assembly
(1) Dial Indicator – Mag back
(1) Carrying case
(1) Operating and maintenance inst.
Rental tool kits are setup and packaged to meet your specific job/application.
This makes it so your tool is ready to go and only has parts necessary for your job, avoiding confusion and minimizing shipping costs.